Fix compilation on Windows
Fix array subscript out of range error in MarchingSquares
Fix normals of mesh constructed from slices
Improve performance of mesh construction from slices
Fixes Connecting / expanding Bottom Layers to Vase Perimeter #253
Fixes Slicing error in vase mode #452
Fixes Slicing Issue (Vase Mode, 0.6mm dmr nozzle) #1887
Fixes Top fill pattern isn't used in spiral vase mode #2533
Fixes Cisar's vase doesn't slice correctly, creates artefacts #3595
When the model is sliced, all the contours are newly oriented
counter-clockwise (even holes), merged and then only the largest area
contour is retained. In perimeter generator, if the largest contour
splits into multiple perimeters, newly only the largest area perimeter
is retained in spiral vase mode. These two changes solve #3595 and similar.
The infill is newly calculated only for the bottom solid layers
if the spiral vase mode is active (removes various unwanted infill
along the vase walls), and the last bottom solid layer is switched
to a top solid pattern (solves #2533).
The thin walls are newly enforced to be disabled in spiral vase mode,
and the "ensure vertical shell wall" is enforced in spiral vase mode
to extend the bottom of the vase to the vase hull (fixes #253).
Drain holes are not allowed to be placed on its own inner surface. This was recently (0e3ebb3)
done by forcing invalidation of the slaposDrillHoles, which also invalidates and therefore
hides the drilled mesh. However, that also hides the hollowed mesh and it is not possible
to place holes inside the cavity.
This change does not dump the drilled mesh, but checks that no raycast hit ends up in a hole.
remove duplicate code
Mark conversion constructors of EigenMesh3D `explicit`
Working on mesh simplification for hollowed interior
Fix bug SPE-1074: crash with empty supports and disabled pad.
fix regression after refactor
Remove unfinished code
Fix missing includes and dumb comments
SPE-1072
Working but flipped normals with the interior.
Testing on treefrog passed
Oversampling for hollowed mesh should not be less than 3x
Flip back normals after simplify and remove redundant test code.
tamasmeszaros